Ronald Florence wrote: > Using the new experimental 10.2 mode, with unstable trees enabled, after > reading in yesterday's email that the gimp package is now available in > the 10.2 tree, I do > > % sudo fink selfupdate-cvs > % sudo fink install gimp > > and get > > [auda:fink/10.2/CVS] ron% sudo fink install gimp > Information about 1129 packages read in 1 seconds. > > Failed: Internal error: node for db3-shlibs already exists > > I'm still eager to install gimp, and would welcome suggestions.
You should rebuild db3 first (and fink reinstall db3-shlibs if it doesn't do it automatically). As I understand the "node for ... already exists" problem, the following happens: gimp BuildDepends on gnome-libs-dev which in turn BuildDepends on "db3 (>= 3.3.11-8)". You probably have an earlier version of db3-shlibs installed, and when fink constructs its dependency list, it first encounters a dependence on db3 without specified version, so it takes the one you already have installed. Later on it sees the dependence on version >=3.3.11-8, but it is not intelligent enough to replace the earlier dependence on an older version by the newer one. In any case, the new gimp will need db3-shlibs-3.3.11-8. -- Martin ------------------------------------------------------- This sf.net email is sponsored by: OSDN - Tired of that same old cell phone? Get a new here for FREE! https://www.inphonic.com/r.asp?r=sourceforge1&refcode1=vs3390 _______________________________________________ Fink-users mailing list [EMAIL PROTECTED] https://lists.sourceforge.net/lists/listinfo/fink-users
