On 17.06.2010 17:39, Johannes Sjölund wrote: > I also applied the patch and tested. See the attached log. > > flashrom v0.9.2-r1049 on Linux 2.6.33-ARCH (x86_64), built with libpci 3.1.7, > GCC 4.5.0 20100520 (prerelease), little endian > flashrom is free software, get the source code at http://www.flashrom.org > > Calibrating delay loop... OS timer resolution is 1 usecs, 927M loops per > second, 10 myus = 11 us, 100 myus = 101 us, 1000 myus = 1000 us, 10000 myus = > 10003 us, 4 myus = 5 us, OK. > Initializing internal programmer > No coreboot table found. > DMI string system-manufacturer: "MSI" > DMI string system-product-name: "MS-7369" > DMI string system-version: "1.0" > DMI string baseboard-manufacturer: "MSI" > DMI string baseboard-product-name: "MS-7369" > DMI string baseboard-version: "1.0" > DMI string chassis-type: "Desktop" > Found chipset "NVIDIA MCP65", enabling flash write... chipset PCI ID is > 10de:0441, This chipset is not really supported yet. Guesswork... > ISA/LPC bridge reg 0x8a contents: 0x40, bit 6 is 1, bit 5 is 0 > Guessed flash bus type is SPI > Found SMBus device 10de:0446 at 00:01:1 > SPI BAR is at 0xfec80000, after clearing low bits BAR is at 0xfec80000 > SPI control is 0x0002, enable=0, idle=0 > Please send the output of "flashrom -V" to [email protected] to help us > finish support for your chipset. Thanks. > OK. > This chipset supports the following protocols: SPI. > [...] > Probing for Macronix MX25L8005, 1024 KB: probe_spi_rdid_generic: id1 0xc2, > id2 0x2014 > Chip status register is 00 > Chip status register: Status Register Write Disable (SRWD) is not set > Chip status register: Bit 6 is not set > Chip status register: Bit 5 / Block Protect 3 (BP3) is not set > Chip status register: Bit 4 / Block Protect 2 (BP2) is not set > Chip status register: Bit 3 / Block Protect 1 (BP1) is not set > Chip status register: Bit 2 / Block Protect 0 (BP0) is not set > Chip status register: Write Enable Latch (WEL) is not set > Chip status register: Write In Progress (WIP/BUSY) is not set > Found chip "Macronix MX25L8005" (1024 KB, SPI) at physical address 0xfff00000. > [...] > No operations were specified. >
Thanks for the log and the testing. Regards, Carl-Daniel -- http://www.hailfinger.org/ _______________________________________________ flashrom mailing list [email protected] http://www.flashrom.org/mailman/listinfo/flashrom
