Hi,

I'm testing an Amontec JtagKey-tiny interface for programming a SST25VF040B eeprom i'm using in a project. The Jtagkey-tiny is detected without problems, it reads the eeprom ID and is detected.

But when i try to read it contents, i get an error:

   $ ./flashrom -p ft2232_spi:type=jtagkey,port=A -Vr test.bin
   flashrom v0.9.3-r1205 on Linux 2.6.32-26-generic (i686), built with
   libpci 3.0.0, GCC 4.4.3, little endian
   flashrom is free software, get the source code at
   http://www.flashrom.org

   Calibrating delay loop... OS timer resolution is 2 usecs, 1000M
   loops per second, 10 myus = 11 us, 100 myus = 91 us, 1000 myus = 904
   us, 10000 myus = 9823 us, 8 myus = 10 us, OK.
   Initializing ft2232_spi programmer
   Using device type Amontec JTAGkey interface A
   Set clock divisor
   SPI clock is 2.000000MHz
   No loopback of TDI/DO TDO/DI
   Set data bits
   [Probings ommited]
   Probing for SST SST25VF040B, 512 KB: probe_spi_rdid_generic: id1
   0xbf, id2 0x258d
   Chip status register is bf
   Chip status register: Block Protect Write Disable (BPL) is set
   Chip status register: Auto Address Increment Programming (AAI) is
   not set
   Chip status register: Bit 5 / Block Protect 3 (BP3) is set
   Chip status register: Bit 4 / Block Protect 2 (BP2) is set
   Chip status register: Bit 3 / Block Protect 1 (BP1) is set
   Chip status register: Bit 2 / Block Protect 0 (BP0) is set
   Chip status register: Write Enable Latch (WEL) is set
   Chip status register: Write In Progress (WIP/BUSY) is set
   Resulting block protection : all blocks
   Found chip "SST SST25VF040B" (512 KB, SPI) at physical address
   0xfff80000.
   [More probings ommited]
   [UNTESTED status warning ommited]
   Some block protection in effect, disabling
   Missing status register write definition, assuming EWSR is needed
   Reading flash... ftdi_write_data: -110, usb bulk write failed
   send_buf failed at end: 1
   Read operation failed!
   FAILED.

As you can see, i tried to low the SPI speed to 2MHz.
Any idea? I know this part is marked as UNTESTED, but it should work as SST25VF080B do.

Thanks,
Carlos

_______________________________________________
flashrom mailing list
[email protected]
http://www.flashrom.org/mailman/listinfo/flashrom

Reply via email to