On Tue, 4 Feb 2014 13:21:58 +0000
Magnus Johansson E <[email protected]> wrote:
> Im working with a HW unit (similar to the ICH10), that has two SPI devices
> connected.
>
> enum ich_spi_mode {
> ich_auto,
> ich_hwseq,
> ich_swseq
> } ich_spi_mode = ich_auto;
>
> And I cannot use the ich_hwseq (which is propsed) because the Intel Chipset
> is only capable of erasing:
> 00: 256 byte
> 01: 4 KB
> 10: 8 KB
> 11: 64 KB
>
> And my flash chip, only support Sector erase/ or Bulk (but I don't like that
> one) and each sector is 256kB.
>
> So how can I proceed here? As I understand I cannot use the hw_seq and have
> to go for the sw_seq. But then how to handle the chip-select? When Im running
> the sw_seq I can only use one flash device, ..
>
> Thanks for support
To my knowledge it is not possible to toggle the chip select by usual
means. The hardware SPI controller does it itself and only if you are
using hardware sequencing. Also, a flash chip without 4kB erase opcodes
does not comply with Intel's requirement for flash chips (and in this
particular case I think these are hard requirements and not just
recommendations as usual).
So, these are questions you should ask Intel; or whoever mated these
flash chips with the board, if at all... :)
--
Kind regards/Mit freundlichen Grüßen, Stefan Tauner
_______________________________________________
flashrom mailing list
[email protected]
http://www.flashrom.org/mailman/listinfo/flashrom
