Actually it is possible to toggle the chipselect by playing with the FADDR register, I will add an option into our flashrom where you can specify the chip-select signal. Then I have to use the sw_seq to be able to erase.
Thx anyway -----Original Message----- From: Stefan Tauner [mailto:[email protected]] Sent: den 4 februari 2014 23:33 To: Magnus Johansson E Cc: [email protected] Subject: Re: [flashrom] question On Tue, 4 Feb 2014 13:21:58 +0000 Magnus Johansson E <[email protected]> wrote: > Im working with a HW unit (similar to the ICH10), that has two SPI devices > connected. > > enum ich_spi_mode { > ich_auto, > ich_hwseq, > ich_swseq > } ich_spi_mode = ich_auto; > > And I cannot use the ich_hwseq (which is propsed) because the Intel Chipset > is only capable of erasing: > 00: 256 byte > 01: 4 KB > 10: 8 KB > 11: 64 KB > > And my flash chip, only support Sector erase/ or Bulk (but I don't like that > one) and each sector is 256kB. > > So how can I proceed here? As I understand I cannot use the hw_seq and have > to go for the sw_seq. But then how to handle the chip-select? When Im running > the sw_seq I can only use one flash device, .. > > Thanks for support To my knowledge it is not possible to toggle the chip select by usual means. The hardware SPI controller does it itself and only if you are using hardware sequencing. Also, a flash chip without 4kB erase opcodes does not comply with Intel's requirement for flash chips (and in this particular case I think these are hard requirements and not just recommendations as usual). So, these are questions you should ask Intel; or whoever mated these flash chips with the board, if at all... :) -- Kind regards/Mit freundlichen Grüßen, Stefan Tauner _______________________________________________ flashrom mailing list [email protected] http://www.flashrom.org/mailman/listinfo/flashrom
