Hi Tim, I just went to the Flex page->Support->Downloads - it's the first thing listed. I guess I used the wrong name referring to it - its version 1.2.5.6 - I got confused. I thought that since it says it needs drive v3.5.0.7171 that is was more current than the 2.0.0.4 one with a similar name two slots down. It's not at all clear to me what the differences are or which one to use.
Best regards, Michael Jones SCSI Toolbox LLC www.scsitoolbox.com 303-972-2072 -----Original Message----- From: Tim Ellison [mailto:[email protected]] Sent: Wednesday, February 03, 2010 10:37 AM To: [email protected]; [email protected] Subject: RE: [FlexEdge] Problem with firmware 2.0.0.6 What URL are you using? That firmware is not on the downloads page. -Tim -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Michael Jones Sent: Wednesday, February 03, 2010 12:15 PM To: [email protected] Subject: [FlexEdge] Problem with firmware 2.0.0.6 I downloaded the new firmware file from the Flex site - I was confused as to why it is a stand-alone program and doesn't use the new "install via the FlexRadio Driver" method. Anyway - it pops up a little cmd window and goes along, clicks my Flex 3K relay when it is done - all seems OK. But, when I try to run PSDE (1.19.3 svn 3524) it hangs a few seconds into initialization. My Flex driver is version 3.5.0.71.71, PAL version is same. I am running this under W7x64 - I am running the firmware install as administrator - all the right stuff as far as I can tell. I can use the Flex Driver to reload 2.0.0.4 and all works fine - that was a big relief! Anyone else seen this behavior? Any suggestions? Best regards, Michael Jones W0STB _______________________________________________ Flexedge mailing list [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for posting topics related to SDR software development and experimentalist who are using alpha and beta versions of the software. _______________________________________________ Flexedge mailing list [email protected] http://mail.flex-radio.biz/mailman/listinfo/flexedge_flex-radio.biz This is the FlexRadio Systems e-mail Reflector called FlexEdge. It is used for posting topics related to SDR software development and experimentalist who are using alpha and beta versions of the software.
