On Wed, 2002-12-11 at 17:20, David Megginson wrote: > Curtis L. Olson writes: > > > I notice that we can't operate the mixture, throttle, flaps via panel > > clicks and some of the knob click areas are a little off. Any thing > > else? The more I run with the 3d panels the more I like them, and the > > more I dislike the 2d panels (although we still need to support 2d > > panels for various reasons.) > > Well, let's start cleaning them up. I don't think we're too far off, > and with Andy's patch to make hotspots visible, it should be easy to > debug the mouse problems and to add new hotspots for 3D instruments.
I'm new to Flightgear, so I don't know if carb heat is simulated. But, in the c172p-3d model, the carburetor heat is stuck in the "on" position. I'd prefer to be able to turn it "off" so that I can get all of the climb performance I can... :-) Also, the aircraft C-FGFS has a bit of a more of a left-yaw and left-roll tendency than the climb-prop equipped 145hp Cessna 172 that I rent(N5394T). The ground-adjustable rudder trim tab on 94T is set so that it flies coordinated without any rudder input at 105mph. Other than that, I really like the model and the 3d panel! This particular model "feels" good and takes about the same amount of effort to fly as the real thing, so I vote for it being the default. -Luke -- Luke Scharf, Jack of Several Trades http://www.ccm.ece.vt.edu/~lscharf _______________________________________________ Flightgear-devel mailing list [EMAIL PROTECTED] http://mail.flightgear.org/mailman/listinfo/flightgear-devel
