"Curtis L. Olson" wrote:
> [...] The simkits stuff are driven by standard servos,
> right? So you could get a little PIC board to run your servos and take
> position commands in from the serial port ... then you just need to send
> the data out the serial port from FG (with perhaps a small amount of
> interface coding.)
I could be easier than that. You can buy ready-to-run serial interface
boards with several PWM outputs - you just need the ability to define
an output bit mask in FlightGear in which you compile the desired
output values.
For the other direction there are simple analogue to serial converters,
some even directly attached to a potentiometer that you can use to set
the altimeter QNH.
Cheers,
Martin.
--
Unix _IS_ user friendly - it's just selective about who its friends are !
--------------------------------------------------------------------------
_______________________________________________
Flightgear-devel mailing list
[email protected]
http://mail.flightgear.org/mailman/listinfo/flightgear-devel
2f585eeea02e2c79d7b1d8c4963bae2d
