Hi Arved,

Thanks for the suggestions, I went ahead and corrected
that.  I finally figured out why, it turned out it is
something to do with printing in Unix to an HP
printer, you have to have the -o option when using the
lp command to print.

Thanks again

Wabei
> 
> Hi, Wabei
> 
> One problem is that you specified an "extent" on
> fo:region-body, which 
> doesn't have that property. This may have been
> handled badly by FOP
> logic.
> 
> Here's some pointers:
> 
> page content rectangle height = page height -
> margin-top(page) - 
>       margin-bottom(page)
> 
> In your case, you'll have 29.7cm - 1cm - 1cm =
> 27.7cm available to you in 
> the page content rectangle.
> 
> Because of your typo, your region-body expects to
> occupy all of the content 
> rectangle for the page except for the bottom 1cm, so
> you have 26.7cm of 
> height assigned to region-body. Assuming that the
> "extent"'s you have for 
> region-before and region-after are exactly what you
> want, you should set a 
> margintop of at least 1cm on region-body, and a
> margin-bottom of at least 
> 11cm on region-body, hence leaving an effective
> content rectangle height for 
> region-body of 27.7cm - 1cm - 11cm = 15.7cm or less.
> 
> I'll check out why you are getting the erroneous -49
> inches, because that's 
> not very helpful whether you put in bad numbers or
> not. :-)
> 
> Hope this helps. I strongly recommend checking out
> the diagrams in the XSL 
> spec for simple-page-master. They should clarify the
> relationships among the 
> 5 regions for you.
> 
> Regards,
> Arved Sandstrom
> 
> Fairly Senior Software Type
> e-plicity (http://www.e-plicity.com)
> Wireless * B2B * J2EE * XML --- Halifax, Nova Scotia
> 
> 
>
---------------------------------------------------------------------
> To unsubscribe, e-mail:
> [EMAIL PROTECTED]
> For additional commands, email:
> [EMAIL PROTECTED]
> 


__________________________________________________
Do You Yahoo!?
Get personalized email addresses from Yahoo! Mail
http://personal.mail.yahoo.com/

---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, email: [EMAIL PROTECTED]

Reply via email to