Hallo Christian,
I tried to implement your piece of advice. I got the following problems:
- tif's remain problematic, even if I create them with their final
dimensions at 72dpi
- 72dpi is a bit low for printouts, e.g. of technical drawings
I'm getting closer and closer to desperation...
Matthias
--- Begin Message ---
Hi Matthias,
did you specify a DPI for the JPGs or TIFFs?? If yes, that might be your
problem! FOP doesn't consider any of this information!
For example:
If you insert a JPG with 1 cm x 1 cm at 300 DPI, it will become
4,16 cm x 4,16 cm because FOP uses 72 DPI!
Christian
-----Ursprüngliche Nachricht-----
Von: Matthias Fischer [mailto:[EMAIL PROTECTED]]
Gesendet: Dienstag, 13. November 2001 14:47
An: [EMAIL PROTECTED]
Betreff: RE: FOP v.0.20.1/Cocoon v.2 rc.2 + Graphics
Hi Christian,
thanks for the quick response. Your answer seems partially correct, since a
bigger graphics was displayed and a smaller one wasn't. However, generally
docs should satisfy the requirement that graphics are no bigger than the
space in fo for displaying them.
Any clue to what concerns the tif's?
Matthias
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, email: [EMAIL PROTECTED]
--- End Message ---
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, email: [EMAIL PROTECTED]
