Ken Sands wrote:
<snip/>
Sorry about that, I'm using 0.91.
Althought your ps-setup-code solution adds to the output postscript it still
won't work, the reason being that each page still has a "setpagedevice" command.
This seems to make the printer (or at least the
xerox 2425 I'm workin with) start a new page. Although it runs in duplex mode
(the duplexing unit is flipping pages as it prints) it's not actually putting
anything on the back, if I remove all but the first setpagedevice instruction
then it works fine.
I too have experienced this problem on the PS Printers I have tested. A
couple of years ago I reported a similar thing to RenderX and they made
a change to only insert the setpagedevice dictionary onto a page if
there was a change from the previous page. I believe something similar
should be implemented in FOP.
<snip/>
Chris
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
