At 02:08 PM 5/21/01 -0700, Chris Hower wrote:
>the reason I want to do this is the .legend on the pcb gerber outputs. I
>can't find a way for eagle to place a different character to represent
>different drill holes. does anyone know if camtastic! can do this? I looked
>through the help and the manual, but found nothing
Okay, maybe I can help with this. Drill drawings are useful for checking
purposes, but not much else, as long as you have a drill file to actually
command the NC drill. The fabricator will massage it if necessary. So I
would not put too much sweat and tears into a drill drawing.
However, if you still want one, and you are able to generate a drill
drawing that shows different symbols at all, you can make a drill chart by
placing one example of each hole in a drawn chart. That was SOP with Tango
PCB until the last rev.
[EMAIL PROTECTED]
Abdulrahman Lomax
P.O. Box 690
El Verano, CA 95433
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
* - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
