Anyone else seen this problem? I didn't find it in the Knowledge Base... If you set the visible layers (Design | Options | Layers, or hot-key L) to show the Top Solder and/or Top Paste layers without the TopLayer (Signal), it doesn't work right. This is easiest to see by doing All Off, then turning on just Top Solder (and maybe Mech 4 so you can see board outline!). Hitting End (View | Refresh) removes the solder mask display. Using the layer tabs you can get it back (hit Mech4, then TopSolder), but it disappears as you scroll, or if you hit End again. Dwight Harm Trax Softworks, Inc. * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/subscrib.html * - or email - * mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Browse or Search previous postings: * http://www.mail-archive.com/[email protected] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
