> Does any know how to stop the starting point of a place track jumping to
another pad when manually routing and another net's rats nest line is in the
way ?
> Can this feature be turned off ?
> P99SE SP6 seems to think you want to route the net connected to the rats
nest line rather than the pad you have clicked on. This is annoying when you
click on the centre of a pad to
> route a track and it jumps to some other place on the pcb just because the
rats nest lines runs over the middle of the first pad.
> Any suggestions welcome.
>
> Mick Beavis
What I have done is configured a Shortcut key (Ctrl-F8 in my particular
case) to toggle the visibility of the RatsNest layer. The shortcut should
invoke the "PCB:DocumentPreferences" process, and it should be invoked with
a parameter of "ConnectLayer = Toggle". This shortcut can then be used to
switch off the ratsnest display before clicking on a pad, and again,
afterwards, to switch this back on again.
Regards,
Geoff Harland.
-----------------------------
E-Mail Disclaimer
The Information in this e-mail is confidential and may be legally
privileged. It is intended solely for the addressee. Access to this
e-mail by anyone else is unauthorised. If you are not the intended
recipient, any disclosure, copying, distribution or any action taken
or omitted to be taken in reliance on it, is prohibited and may be
unlawful. Any opinions or advice contained in this e-mail are
confidential and not for public display.
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
* - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
