how does one edit the .ins files
Ted
-----Original Message-----
From: Rusty Garfield [mailto:[EMAIL PROTECTED]]
Sent: Thursday, May 24, 2001 3:10 PM
To: Protel EDA Forum
Subject: Re: [PEDA] Manual route rats nest jump
At 10:22 AM 5/24/2001 +1000, you wrote:
> > Does any know how to stop the starting point of a place track jumping to
>another pad when manually routing and another net's rats nest line is in
the
>way ?
> > Can this feature be turned off ?
> > P99SE SP6 seems to think you want to route the net connected to the rats
>nest line rather than the pad you have clicked on. This is annoying when
you
>click on the centre of a pad to
> > route a track and it jumps to some other place on the pcb just because
the
>rats nest lines runs over the middle of the first pad.
> > Any suggestions welcome.
> >
> > Mick Beavis
>
>What I have done is configured a Shortcut key (Ctrl-F8 in my particular
>case) to toggle the visibility of the RatsNest layer. The shortcut should
>invoke the "PCB:DocumentPreferences" process, and it should be invoked with
>a parameter of "ConnectLayer = Toggle". This shortcut can then be used to
>switch off the ratsnest display before clicking on a pad, and again,
>afterwards, to switch this back on again.
>
>Regards,
>Geoff Harland.
Try these below:
Make your own icons and the caps as you see them below.
By the way if you are running winn2000 you will have to change PBRUSH.EXE
with MSPAINT.EXE in
two files. Client99se.ini under winnt and Client99se.ins under design
explorer 99 se. Otherwise
your icon editor will not work with client.
Process PCB:ShowConnections
Parameters Show= All|$Description=SHOW ALL NETS
This shows all connections
Process PCB: ShowConnections
Prameters Show = Net
This turns them on one at a time
Process PCB:HideConnections
Parameters $Description=HIDE ALL CONNECTIONS (NO PARAMETERS NEEDED
THIS JUST SHOWS WHAT
YOU CAN DISPLAY IF THE
MOUSE IS HELD OVER
THE ICON)
This turns them all off
Process PCB: HideConnections
Prarmeters Hide = Net|$Description=HIDE ONE AT A TIME
This turns them off one at a time as you point at a connection( ratsnest)
and click the mouse.
Process PCB:ShowConnections
Parameters Show= All|$Description=SHOW ALL NETS
This turns them all on.
Rusty Garfield
Development Technician IV
Sugar Land Product Center
(281) 285-7611 (voice)
(281) 285-7619 (fax)
[EMAIL PROTECTED] (e-mail)
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
* - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
