I was about to reply that there is a type, "Unspecified" -- then I looked to be sure
and it wasn't there! It IS there for ports and sheet entries (which is what I was
thinking of), so it seems like it would be more consistent to also have it available
for pins. A good addition for the "suggested enhancements" list.
-----Original Message-----
From: Phillip Stevens [mailto:[EMAIL PROTECTED]]
Sent: Wednesday, May 30, 2001 5:28 PM
After assigning a lot of pins (324 of em..) on a BGA the other day I
got a couple of ideas for the future maybe?
- A new electrical type in the electrical type pull down called "Undefined".
This would make it easier to spot as yet unassigned electrical types in a design.
Since Protel defaults to "passive" here, it is hard to know when you
look at a part definition later, if it really is supposed to be passive, or you
just didn't know what the pin should have been when you created it.
<snip>
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
* - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
