Hi Scott,
this error shows up when you try to update a 2-pin PCB component with a
3-pin schematic component. Please check the footprint you defined for the
3-pin connector in schematic. I am pretty sure this refers to a 2-pin PCB
decal. If the PCB decal has more than 2 pins defined, then they are named
differently from the schematic component.
Gisbert Auge
N.A.T. GmbH
"Pierce, Scott" <[EMAIL PROTECTED]> on 27.06.2001 16:13:43
Please respond to "Protel EDA Forum" <[EMAIL PROTECTED]>
To: "'[EMAIL PROTECTED]'" <[EMAIL PROTECTED]>
cc:
Subject: [PEDA] DESIGN UPDATE
Hi all,
Can someone tell me why when doing design update I get an error: Node not
found. I am adding a 3 pin connector. The system sees pin 1 and 2 but not
3.
I've spent about 3 hours on this. Pin 3 is hooked up the same as Pins 1 and
2. They are the same type of pins. The connector is ok. The symbol is ok.
Everything seems ok. I ran a netlist for the schematic and everything there
is fine. If this would be the first time for doing the update the connector
would be connected correctly.
Thanks for any information.
Scott L. Pierce
Krautkramer, Inc.
50 Industrial Park Rd.
Lewistown, Pa. 17044
(717) 242-0320 ext. 396
Fax: (717) 242-2990
E-mail: [EMAIL PROTECTED]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/subscrib.html
* - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
