Hi all,
I have to conduct an experimentation for railway application to localize
the trains and eventually distinguish the track in parellal tracks
scenarios.
The train could run up to 300 km/h. I'm testing a Denga10 receiver
(http://www.onetalent-gnss.com/ideas/usb-hw-receivers/denga10) 10 Hz
output and a low cost antenna Tallysmann TW2410. I'm using RTKNavi and 2
Gnss permanent station networks (Italpos Leica Geosystems and Netgeo
Topcon). My question is: "When I get Master auxiliary corrections from
Leica geosystems network, RTKLIB uses Auxiliary stations message? If so,
where is locate the source code for the positioning?
Then I bougth also another Denga10 to set up an RTK system: one Denga10
as Master base and one as Rover. I'll post the results asap.
Regards
--
Fabrizio Toni*
**//*//
_______________________________________________
This message is sent to you from [email protected] mailing list.
Visit http://lists.osgeo.org/mailman/listinfo/foss-gps to manage your
subscription
For more information, check http://wiki.osgeo.org/wiki/FOSS-GPS
