Dear Fabrizio
My question is: "When I get Master auxiliary corrections from
Leica geosystems network, RTKLIB uses Auxiliary stations message?
No.
RTKLIB does not support MAC.
You need to convert MAC corrections to VRS observation
data by yourself.
regards,
Tomoji TAKASU
--------------------------------------------------
From: "Fabrizio Toni" <[email protected]>
Sent: Saturday, June 16, 2012 9:04 PM
To: <[email protected]>
Subject: [FOSS-GPS] RTKLIB and Master Auxiliary approach
Hi all,
I have to conduct an experimentation for railway application to localize
the trains and eventually distinguish the track in parellal tracks
scenarios.
The train could run up to 300 km/h. I'm testing a Denga10 receiver
(http://www.onetalent-gnss.com/ideas/usb-hw-receivers/denga10) 10 Hz
output and a low cost antenna Tallysmann TW2410. I'm using RTKNavi and 2
Gnss permanent station networks (Italpos Leica Geosystems and Netgeo
Topcon). My question is: "When I get Master auxiliary corrections from
Leica geosystems network, RTKLIB uses Auxiliary stations message? If so,
where is locate the source code for the positioning?
Then I bougth also another Denga10 to set up an RTK system: one Denga10
as Master base and one as Rover. I'll post the results asap.
Regards
--
Fabrizio Toni*
**//*//
_______________________________________________
This message is sent to you from [email protected] mailing list.
Visit http://lists.osgeo.org/mailman/listinfo/foss-gps to manage your
subscription
For more information, check http://wiki.osgeo.org/wiki/FOSS-GPS
_______________________________________________
This message is sent to you from [email protected] mailing list.
Visit http://lists.osgeo.org/mailman/listinfo/foss-gps to manage your
subscription
For more information, check http://wiki.osgeo.org/wiki/FOSS-GPS
