Hi I have the current setup in an active/active configuration:
||========CORE=======|| || || Serveriron00==///==Serveriron01 The link between the two serverirons (running switch code base 09.5.02mTF3) is on a separate VLAN with no kind of STP enabled and is a trunk made up of two physical ethernet links, 2/5 and 2/6 with 2/5 being the primary trunk port. Below is a snippet of the configuration. Serveriron00 <snip> ! trunk switch ethe 2/1 to 2/4 config-trunk-ind monitor ethe-port-monitored 2/1 ethe 2/7 both monitor ethe-port-monitored 2/2 ethe 2/7 both monitor ethe-port-monitored 2/3 ethe 2/7 both monitor ethe-port-monitored 2/4 ethe 2/7 both trunk switch ethe 2/5 to 2/6 config-trunk-ind ! ! server active-active-port ethe 2/5 vlan-id 200 config-sync sender ethernet 2/1 mac 0012.f2af.2620 ! ! server source-nat server source-nat-ip 10.0.0.100 255.0.0.0 0.0.0.0 port-range 2 ! </snip> Serveriron01 <snip> ! trunk switch ethe 2/1 to 2/4 trunk switch ethe 2/5 to 2/6 ! ! server active-active-port ethe 2/5 vlan-id 200 config-sync receiver ethernet any ! ! server source-nat server source-nat-ip 10.0.0.100 255.0.0.0 0.0.0.0 port-range 1 ! </snip> Serveriron00#sh vlan 200 Total PORT-VLAN entries: 2 Maximum PORT-VLAN entries: 32 legend: [S=Slot] PORT-VLAN 200, Name ACTIVE-ACTIVE, Priority level0, Spanning tree Off Untagged Ports: (S2) 5 6 Tagged Ports: None Uplink Ports: None DualMode Ports: None Serveriron01#sh vlan 200 Total PORT-VLAN entries: 2 Maximum PORT-VLAN entries: 32 legend: [S=Slot] PORT-VLAN 200, Name ACTIVE-ACTIVE, Priority level0, Spanning tree Off Untagged Ports: (S2) 5 6 Tagged Ports: None Uplink Ports: None DualMode Ports: None In order to have keep-alives purely over that trunk as opposed to going through the CORE, would I enter the following on _both_ Serverirons? (config)#link-keepalive ethernet 2/5 ethernet 2/6 The documentation of the code base I am running is a little sparse and all I can find on this is in the document "Foundry Switch and Router Installation and Basic Configuration Guide" where it talks about configuring UDLD. Apologies, but I am a little confused. Mike _______________________________________________ foundry-nsp mailing list [email protected] http://puck.nether.net/mailman/listinfo/foundry-nsp
