Hi, B2P08001t works fine with IPv6. Regards,
Clément On Tue, 2009-12-08 at 11:55 +0100, Gunther Stammwitz wrote: > Hello Clement, > > which exact software tree are you referring to? > > I was trying to enable v6 on 8001u (08.0.01uT53 / B2R08001u.bin) but didn't > have success. > Is the B2R-image the correct version set? My modules are jetcore (J-BxGMR4). > > > Can't find the appropriate manual :-( > The v6 manual from April (IPv6_April2009_Config_Guide.pdf) just says > IronWare > Software 07.7.02 and higher. > > > Thanks, > Gunther > > [apologies for dupes - had to send the message again due to spam protection] > > > -----Ursprüngliche Nachricht----- > > Von: [email protected] [mailto:foundry-nsp- > > [email protected]] Im Auftrag von Clement Cavadore > > Gesendet: Donnerstag, 8. Oktober 2009 00:55 > > An: Joseph Hardeman > > Cc: [email protected] > > Betreff: Re: [f-nsp] IPv6 on BigIron? > > > > Hi, > > > > > > Le mercredi 07 octobre 2009 à 18:19 -0400, Joseph Hardeman a écrit : > > > Yes, the J-BxGMR4 will do IPv6, but you need to have a software > > > version greater than 08.0.x. > > > > > > More precisely: You need Jetcore module *and* software equals to 08.x. > > 9.x or 7.x do not have any IPv6 features. > > > > However, Jetcore manager runs a fully software-based IPv6 routing. > > > > Regards, > > > > Clément > > > > _______________________________________________ > > foundry-nsp mailing list > > [email protected] > > http://puck.nether.net/mailman/listinfo/foundry-nsp > > > _______________________________________________ > foundry-nsp mailing list > [email protected] > http://puck.nether.net/mailman/listinfo/foundry-nsp _______________________________________________ foundry-nsp mailing list [email protected] http://puck.nether.net/mailman/listinfo/foundry-nsp
