Hi Niels and Ronald, Thanks for your replies.
The board is a 100/1000-board (is that what we call HF?), while the SFP is 1G-only to my knowledge. The board in the RX is a 1G-only too, which may be a clue. UDLD is not enabled on any of the devices involved and I have played around with 'gig-default' and its three options without any luck. Finally, the 'speed-duplex' setting seems not applicable/available on this type of board. I am going to contact the vendor explaining this situation, perhaps they can assist. Since, of course, there is a customer installation involved I was hoping to solve things without sending optics back to the vendor :-) Best regards, Jorik Jonker Special Projects, Netherlands [email protected] +31 53 434 0570 TEL +31 53 436 3098 FAX KvK: 06092246 EQUINIX -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Niels Bakker Sent: donderdag 17 februari 2011 16:17 To: [email protected] Subject: Re: [f-nsp] SFP-T in XMR * [email protected] (Jorik Jonker) [Thu 17 Feb 2011, 16:09 CET]: >Just ran into this bizarre problem when using a E1MG-TX (1G copper >RJ45 SFP) in a NI-XMR-1Gx20-SFP board in a XMR. > >The "other side", in this case a laptop, HP switch, FESX424 or >whatever 1G RJ45 capable device thinks it has link up (Full 1G) >while the XMR holding the SFP still has link down. When I put this >SFP into a RX-BI-24F in a RX, both sides have 1G full link up. When >I use a different XMR or a different board I get the same situation. > >Is there some mysterious setting that I should fiddle with in order >to convince the XMR to proceed into "link up"? With the caveat that I've not used copper SFPs myself, is the XMR an HF blade? Or do you maybe have UDLD ("link-keepalive") enabled? Have you tried "gig-default auto-gig"? -- Niels. -- _______________________________________________ foundry-nsp mailing list [email protected] http://puck.nether.net/mailman/listinfo/foundry-nsp This email is from Equinix Europe Limited or one of its associated/subsidiary companies. This email, and any files transmitted with it, contains information which is confidential, may be legally privileged and is solely for the use of the intended recipient. If you have received this email in error, please notify the sender and delete this email immediately. Equinix Europe Limited. Registered Office: Quadrant House, 4 Thomas More Square, London E1W 1YW. Registered in England and Wales, No. 6293383. _______________________________________________ foundry-nsp mailing list [email protected] http://puck.nether.net/mailman/listinfo/foundry-nsp
