On Thu, Jun 21, 2012 at 04:03:54PM +0300, Alexander Shikoff wrote:/
/>/ //
/>/ pbif_ager_linklist_init: PBIF #0 pLinkListEntry base 0x08f24000
/>/ rw2_cpu_pkt_buf_init : rx_priority_mode set failed after 6 tries.
/>/ Module is dow
/>/ NetIron XMR/MLX Boot Monitor Version 5.3.00
/>/ Enter 'b' to stop at boot monitor
/>/
/>/ ... and repeats again.
/
Thanks to all who answered including private mails.
It was not a problem of wrong module type in configuration etc.
I've downgraded IronWare to 5.2 and now modules are ok:
telnet at NetIron <http://puck.nether.net/mailman/listinfo/foundry-nsp>
MLX-16 Router#show module
Module Status Ports Starting MAC
M1 (upper): BR-MLX-MR2-M Management Module Active
M2 (lower):
F1: NI-X-HSF Switch Fabric Module Active
F2: NI-X-HSF Switch Fabric Module Active
F3: NI-X-HSF Switch Fabric Module Active
F4:
S1: NI-MLX-10Gx8-D 8-port 10GbE (D) Module CARD_STATE_UP 8
0024.38a1.c900
S2: NI-MLX-10Gx8-D 8-port 10GbE (D) Module CARD_STATE_UP 8
0024.38a1.c930
I will try upgrading to 5.3 later once more time in order to check whether
it causes that problem.
Hi,
we were facing the same problem with a BR-MLX-10Gx4-X card in an XMR
chassis. The card constantly rebooted after the message
rw2_cpu_pkt_buf_init : rx_priority_mode set failed after 6 tries.
We were running software 5.3.0b. We performed an upgrade to 5.3.0c and
after that all was fine:
#show module
Module Status Ports Starting MAC
M1 (left): NI-XMR-MR Management Module Active
..
S3: BR-MLX-10Gx4-X 4-port 10GbE Module CARD_STATE_UP 4 748e.f85c.2d60
It presume therefore there is an issue with version 5.3.0b in relation
with this linecard.
Best,
- Jeroen
/
/
_______________________________________________
foundry-nsp mailing list
[email protected]
http://puck.nether.net/mailman/listinfo/foundry-nsp
