Your application image doesn't match then most likely.
Somehow the linecard doesn't recognize the difference between some 5300x
and 5400x application images, so it doesn't do an automatic lp sync on
boot. Also attempting a manual lp sync doesn't see a problem.
Boot the card in interactive/monitor mode ('rcon lp 3' from console to
get into the linecard shell and hit the b when it says so) and then make
sure you upgrade the lp monitor, boot, application, xpp, sp2 and xgmac
images from the generic commandline in your XMR. Then powercycle the
linecard with a power-off and power-on and and it should work.
On 7/4/13 2:33 PM, Jeroen Oldenhof wrote:
On Thu, Jun 21, 2012 at 04:03:54PM +0300, Alexander Shikoff wrote:/
/>/ //
/>/ pbif_ager_linklist_init: PBIF #0 pLinkListEntry base 0x08f24000
/>/ rw2_cpu_pkt_buf_init : rx_priority_mode set failed after 6 tries.
/>/ Module is dow
/>/ NetIron XMR/MLX Boot Monitor Version 5.3.00
/>/ Enter 'b' to stop at boot monitor
/>/
/>/ ... and repeats again.
/
Thanks to all who answered including private mails.
It was not a problem of wrong module type in configuration etc.
I've downgraded IronWare to 5.2 and now modules are ok:
telnet at NetIron <http://puck.nether.net/mailman/listinfo/foundry-nsp>
MLX-16 Router#show module
Module Status Ports Starting MAC
M1 (upper): BR-MLX-MR2-M Management Module Active
M2 (lower):
F1: NI-X-HSF Switch Fabric Module Active
F2: NI-X-HSF Switch Fabric Module Active
F3: NI-X-HSF Switch Fabric Module Active
F4:
S1: NI-MLX-10Gx8-D 8-port 10GbE (D) Module CARD_STATE_UP 8
0024.38a1.c900
S2: NI-MLX-10Gx8-D 8-port 10GbE (D) Module CARD_STATE_UP 8
0024.38a1.c930
I will try upgrading to 5.3 later once more time in order to check whether
it causes that problem.
Hi,
we were facing the same problem with a BR-MLX-10Gx4-X card in an XMR
chassis. The card constantly rebooted after the message
rw2_cpu_pkt_buf_init : rx_priority_mode set failed after 6 tries.
We were running software 5.3.0b. We performed an upgrade to 5.3.0c and
after that all was fine:
#show module
Module Status Ports Starting MAC
M1 (left): NI-XMR-MR Management Module Active
..
S3: BR-MLX-10Gx4-X 4-port 10GbE Module CARD_STATE_UP 4 748e.f85c.2d60
It presume therefore there is an issue with version 5.3.0b in relation
with this linecard.
Best,
- Jeroen
/
/
_______________________________________________
foundry-nsp mailing list
[email protected]
http://puck.nether.net/mailman/listinfo/foundry-nsp
--
Jeroen Wunnink
Senior Network Engineer / NOC Team Lead
Atrato IP Networks
[email protected]
Phone: +31 20 82 00 623
_______________________________________________
foundry-nsp mailing list
[email protected]
http://puck.nether.net/mailman/listinfo/foundry-nsp
