For clarity, the 'secondary' is only needed if you are adding a secondary address in the same subnet as an existing address. You can put multiple addresses on a single interface without any trouble at all.
-- Eldon Koyle Information Technology Utah State University -- When the revolution comes, count your change. On Jul 05 14:09-0500, Aaron Wendel wrote: > Leave off the "secondary" > > On Jul 5, 2013, at 1:55 PM, Youssef Bengelloun-Zahr <[email protected]> wrote: > > > Hello community, > > > > This has got to be an hallucination : > > > > telnet@er01-par01(config-vif-4)#ip address XXX.XXX.XXX.XXX 255.255.255.0 > > secondary > > IP/Port: Errno(12) Assign primary ip address on specified subnet first > > > > Really !?! Any other way to configure secondary address but on a different > > subnet ? > > > > Running MLXe boxes with 540b > > > > Best regards. > > > > -- > > Youssef BENGELLOUN-ZAHR > > _______________________________________________ > > foundry-nsp mailing list > > [email protected] > > http://puck.nether.net/mailman/listinfo/foundry-nsp > > _______________________________________________ > foundry-nsp mailing list > [email protected] > http://puck.nether.net/mailman/listinfo/foundry-nsp > _______________________________________________ foundry-nsp mailing list [email protected] http://puck.nether.net/mailman/listinfo/foundry-nsp
