Out of curiosity, how much addresses can I configure on interface ? Is it also valide for v6 ?
Y. 2013/7/5 Eldon Koyle <[email protected]> > For clarity, the 'secondary' is only needed if you are adding a > secondary address in the same subnet as an existing address. You can > put multiple addresses on a single interface without any trouble at all. > > -- > Eldon Koyle > Information Technology > Utah State University > -- > When the revolution comes, count your change. > > On Jul 05 14:09-0500, Aaron Wendel wrote: > > Leave off the "secondary" > > > > On Jul 5, 2013, at 1:55 PM, Youssef Bengelloun-Zahr <[email protected]> > wrote: > > > > > Hello community, > > > > > > This has got to be an hallucination : > > > > > > telnet@er01-par01(config-vif-4)#ip address XXX.XXX.XXX.XXX > 255.255.255.0 secondary > > > IP/Port: Errno(12) Assign primary ip address on specified subnet first > > > > > > Really !?! Any other way to configure secondary address but on a > different subnet ? > > > > > > Running MLXe boxes with 540b > > > > > > Best regards. > > > > > > -- > > > Youssef BENGELLOUN-ZAHR > > > _______________________________________________ > > > foundry-nsp mailing list > > > [email protected] > > > http://puck.nether.net/mailman/listinfo/foundry-nsp > > > > _______________________________________________ > > foundry-nsp mailing list > > [email protected] > > http://puck.nether.net/mailman/listinfo/foundry-nsp > > > _______________________________________________ > foundry-nsp mailing list > [email protected] > http://puck.nether.net/mailman/listinfo/foundry-nsp > -- Youssef BENGELLOUN-ZAHR
_______________________________________________ foundry-nsp mailing list [email protected] http://puck.nether.net/mailman/listinfo/foundry-nsp
