So neither "show span" nor "show 802-1w" shows spanning tree running? Is this turboiron running routing code or switch code? IIRC, the default is single spanning tree on switch code and no spanning tree on routing code.
-- Eldon Koyle On May 17, 2016 2:12 PM, "Nick Cutting" <[email protected]> wrote: > I think I have found my answer – as this switch is not participating in > spanning tree – I believe that : > > > > STP configured to ON, priority is level0 > > > > Is forwarding the BPDU’s unmodified. > > > > Would I be correct in this assumption? I see the correct Bridge ID’s as if > this switch is not there. > > > > *From:* Nick Cutting > *Sent:* Tuesday, May 17, 2016 3:26 PM > *To:* Nick Cutting; Eldon Koyle > *Cc:* [email protected] > *Subject:* RE: [f-nsp] Spanning tree on brocade > > > > Now I have another switch – that has no IEEE spanning tree, No 802w, and > no pvst configured. > > > > however, it says it is enabled on the port?? > > > > 10GigabitEthernet23 is up, line protocol is up > > Hardware is 10GigabitEthernet, address is 748e.f821.57d3 (bia > 748e.f821.57e9) > > Configured speed 10Gbit, actual 10Gbit, configured duplex fdx, actual fdx > > Member of L2 VLAN ID 501, port is untagged, port state is FORWARDING > > BPDU guard is Disabled, ROOT protect is Disabled > > Link Error Dampening is Disabled > > * STP configured to ON, priority is level0* > > > > Now – the loops prevention is on the otherside – and they are receiving > BPDU’s on this switch – how can this be possible with no stp config? > > > > Can someone please elaborate on the port level spanning tree? > > > > Thanks ! > > _______________________________________________ > foundry-nsp mailing list > [email protected] > http://puck.nether.net/mailman/listinfo/foundry-nsp >
_______________________________________________ foundry-nsp mailing list [email protected] http://puck.nether.net/mailman/listinfo/foundry-nsp
