Hi Raph, I wouldn't do that. There is the risk to not be able to restart the board again since it depends from the startup state of the OG25 pin. If it starts at low state you will not be able to start Linux again.
If you want to try, connect only J7.13 to J13.1 (the pin nearer to the white J2 header) through a 330 Ohm resistor. If the board starts properly try the command: setbits -p g -b 25 -s 0 The board should restart. If the board does not start at all after the connection or it continuously restarts you have to choose a pin that is a input by default like PA0. Then during normal working if you turn this pin as output as put it at low state you should reach your goal. Attention: This procedure can cause permanent damage to the board if not done properly so it has to be carried out at your own risk. My suggestion is to restart the board with the "reboot" command. There is no reason why the command "reboot" should not work. Infact if the board locks up, it will not execute even the setbits command so there are no reasons to realize the connection between J7.13 and J13.1. Otherwise please let me know why you need a hard reset. Best regards, Roberto Asquini mc83000 ha scritto: > > Ok, > > I can connect : J7.1 and J7.13 to J13 and excute this command : > > setbits -p g -b 25 -s 1 > > to make a hard reset without risk ? > > Raph > > --- In [email protected] <mailto:foxboard%40yahoogroups.com>, > Roberto Asquini <[EMAIL PROTECTED]> wrote: > > > > Dear Raph, > > > > to restart the Fox Board you can take two approaches: software > reboot or > > hardware restart. > > > > On the software side you can just put the command "reboot" ina script > > and instruct the Operating system to start that script every day > with cron. > > > > On the hardware side the more reliable way to restart the Fox Board is > > NOT by means of the reset jumper J9. > > The best way is to use the shutdown jumper J13 since the hardware reset > > is not 100% reliable (see Axis ETRAXLX100 known issues in their > website). > > The Shutdown function has been added in the project for this > purpose, to > > put the whole +3.3V load onboard Fox in sleep since it acts on the > +3.3V > > power regulator. > > > > Best regards, > > > > Roberto Asquini > > > > mc83000 ha scritto: > > > > > > Hi, > > > > > > I need to restart electrically my foxboard, when it crash or every day > > > > > > Have you a solution for me ? > > > > > > Thanks > > > > > > Raph > > > > > > > > > > > > -- > > Roberto Asquini > > Acme Systems srl > > [EMAIL PROTECTED] > > http://www.acmesystems.it <http://www.acmesystems.it> > > > > -- Roberto Asquini Acme Systems srl [EMAIL PROTECTED] http://www.acmesystems.it
