Hi Roberto, I need to restart electrically, because "reboot" don't shutdown USB ! :(
Raph --- In [email protected], Roberto Asquini <[EMAIL PROTECTED]> wrote: > > Hi Raph, > > I wouldn't do that. There is the risk to not be able to restart the > board again since it depends from the startup state of the OG25 pin. If > it starts at low state you will not be able to start Linux again. > > If you want to try, connect only J7.13 to J13.1 (the pin nearer to the > white J2 header) through a 330 Ohm resistor. > > If the board starts properly try the command: > setbits -p g -b 25 -s 0 > > The board should restart. > > If the board does not start at all after the connection or it > continuously restarts you have to choose a pin that is a input by > default like PA0. Then during normal working if you turn this pin as > output as put it at low state you should reach your goal. > > Attention: This procedure can cause permanent damage to the board if not > done properly so it has to be carried out at your own risk. > > My suggestion is to restart the board with the "reboot" command. There > is no reason why the command "reboot" should not work. Infact if the > board locks up, it will not execute even the setbits command so there > are no reasons to realize the connection between J7.13 and J13.1. > > Otherwise please let me know why you need a hard reset. > > Best regards, > > Roberto Asquini > > mc83000 ha scritto: > > > > Ok, > > > > I can connect : J7.1 and J7.13 to J13 and excute this command : > > > > setbits -p g -b 25 -s 1 > > > > to make a hard reset without risk ? > > > > Raph > > > > --- In [email protected] <mailto:foxboard%40yahoogroups.com>, > > Roberto Asquini <asquini@> wrote: > > > > > > Dear Raph, > > > > > > to restart the Fox Board you can take two approaches: software > > reboot or > > > hardware restart. > > > > > > On the software side you can just put the command "reboot" ina script > > > and instruct the Operating system to start that script every day > > with cron. > > > > > > On the hardware side the more reliable way to restart the Fox Board is > > > NOT by means of the reset jumper J9. > > > The best way is to use the shutdown jumper J13 since the hardware reset > > > is not 100% reliable (see Axis ETRAXLX100 known issues in their > > website). > > > The Shutdown function has been added in the project for this > > purpose, to > > > put the whole +3.3V load onboard Fox in sleep since it acts on the > > +3.3V > > > power regulator. > > > > > > Best regards, > > > > > > Roberto Asquini > > > > > > mc83000 ha scritto: > > > > > > > > Hi, > > > > > > > > I need to restart electrically my foxboard, when it crash or every day > > > > > > > > Have you a solution for me ? > > > > > > > > Thanks > > > > > > > > Raph > > > > > > > > > > > > > > > > > -- > > > Roberto Asquini > > > Acme Systems srl > > > asquini@ > > > http://www.acmesystems.it <http://www.acmesystems.it> > > > > > > > > > > -- > Roberto Asquini > Acme Systems srl > [EMAIL PROTECTED] > http://www.acmesystems.it >
