It seems Dan Langille wrote:
> I have one box which is slow to boot under -current (mind you, I've never
> run anything but -current on this box). In my previous message, there
> were two excessively long pauses. One after ata0 appears and another
> after ata-isa0 appears. I've been able to eliminate one of these pauses.
> I removed this from my kernel:
>
> device ata1 at isa? port IO_WD2 irq 15
> All times are approximate (I had to count, no watches to hand).
>
> ATA and ATAPI devices
> device ata0 at isa? port IO_WD1 irq 14
> #device ata1 at isa? port IO_WD2 irq 15
> device ata
> device atadisk # ATA disk drives
> #device atapicd # ATAPI CDROM drives
> #device atapifd # ATAPI floppy drives
> #device atapist # ATAPI tape drives
> options ATA_STATIC_ID #Static device numbering
> #options ATA_ENABLE_ATAPI_DMA #Enable DMA on ATAPI
> devices
>
> Did I miss anything else which might be useful?
since this is a PCI system you should only have:
device ata
device atadisk # ATA disk drives
options ATA_STATIC_ID #Static device numbering
BUT if the second channel is enabled in the BIOS and the hardware plays
foul on probe, it will be probed for devices for the std timeout which
is 31s pr device, give or take...
-Søren
To Unsubscribe: send mail to [EMAIL PROTECTED]
with "unsubscribe freebsd-current" in the body of the message
