On 09/10/2016 09:36, Matthias Apitz wrote:
> El día Saturday, October 08, 2016 a las 10:17:07PM +0300, Andriy Gapon 
> escribió:
>> On 08/10/2016 21:07, Matthias Apitz wrote:
>>> I have now produced a memstick with (unpatched) r306769 of October 6. It 
>>> boots
>>> fine in my Acer C720 Chromebook and the moused is working fine with the
>>> cyapa(4) driver. I will apply tomorrow the above v4 patch or is there
>>> anything newer? And will test/report.
>> v4 is the latest.  Thanks!
> The patch applies cleanly, the 'make buildkernel' does fine and system
> boots, but cyapa(4) can not bring the device out of bootstrap. The verbose 
> dmesg
> is here http://www.unixarea.de/dmesg-00.txt 
> And yes, I have in /boot/device.hints:

Well, comparing the hints and the boot message, you have exactly the problem
that I feared many people would have until we add auto-probing to isl and cyapa.

Basically it's easy to connect the dots once you know what they are.  You hint
that isl and cyapa should be on iicbus0 or iicbus1.  But iicbus0 is connected to
iicbb0 which is intel_iicbb0 on drmn0, which is a video card.  That is clearly
wrong.  And a similar thing with iicbus1: <Philips I2C bus> on intel_gmbus0.
But later you have:
iicbus14: <Philips I2C bus> on ig4iic0
iicbus15: <Philips I2C bus> on ig4iic1
So, in your case, and with that probing order (hopefully it not changes from
boot to boot), you should use those two buses to look for isl and cyapa.

Examining output of devinfo -v -r should be even easier than going through 
Hope this helps.

> ...
> # The change moves the drivers from the SMBus to the I2C bus and as such some
> # configuration changes are required.
> # Namely, you will now need iicbus driver either in the kernel configuration 
> or as
> # a module.  For now the smbus driver is also required.
> # You also need to add some entries to /boot/device.hints:
> # 
> hint.isl.0.at="iicbus0"
> hint.isl.0.addr=0x88
> hint.isl.1.at="iicbus1"
> hint.isl.1.addr=0x88
> hint.cyapa.0.at="iicbus0"
> hint.cyapa.0.addr=0xce
> hint.cyapa.1.at="iicbus1"
> hint.cyapa.1.addr=0xce
> # 
> # The hints are required because auto-probing (either via the bus enumeration 
> or
> # self-identification) is disabled for now for safety reason.
> # Also, as I understand, the Intel chipset used in the supported Chromebooks
> # provides to i2c buses (possibly in addition in an smbus) and I am not sure 
> on
> # which of the i2c buses the devices reside.
> Please let me know what to check/debug.
>       matthias

Andriy Gapon
freebsd-current@freebsd.org mailing list
To unsubscribe, send any mail to "freebsd-current-unsubscr...@freebsd.org"

Reply via email to