On Sat, Nov 22, 2008 at 8:43 AM, Pieter Donche <[EMAIL PROTECTED]> wrote: > On Sat, 22 Nov 2008, Glen Barber wrote: > >>> The PC with WMware is connect to internet. Should one configure >>> Ethernet then. If yes, what static IP parameters must one enter?? >> >> This would be contingent on how you have networking set up. Do you >> have NAT or Bridged only? If NAT, use rc.conf with the inet address >> of your choice and the netmask for your NAT. > > My PC is connected to Internet using an ADSL modem to connect to an ISP. > It uses IP 10.0.0.somevalue, netmask 255.255.255.0, no gateway specified > and two DNS server IP addresses which my ISP asked to use. > > Is this 'NAT' or 'Bridged'. >
You'd have to tell me; it's your VM. Check the network settings in the management interface. > Can I enter values and then what values, for host, domain, IPV4 gateway, > Name server, IPV4 address, netmask in the screen presented during FreeBSD > install > or should i use Cancel in that screen and make changes in system files (and > what changes in what system files)? > Either will work. -- Glen Barber "If you have any trouble sounding condescending, find a Unix user to show you how it's done." --Scott Adams _______________________________________________ freebsd-questions@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"