On Thu, Oct 09, 2003 at 03:23:15AM -0400, Alexey Koptsevich wrote: > > Hi, > > I have a problem with the network card Linksys USB100TX. The hardware > itself is known to be working, but not under FreeBSD. > > Here is dmesg: > > Oct 8 21:10:39 pyosik kernel: aue0: LINKSYS Inc. LINKSYS USB Adapter, rev > 1.10/1.01, addr 2 > Oct 8 21:10:40 pyosik kernel: aue0: Ethernet address: 00:e0:98:82:f3:e6 > Oct 8 21:10:40 pyosik kernel: miibus1: <MII bus> on aue0 > Oct 8 21:10:40 pyosik kernel: bmtphy0: <BCM5201 10/100baseTX PHY> on miibus1 > Oct 8 21:10:40 pyosik kernel: bmtphy0: 10baseT, 10baseT-FDX, 100baseTX, > 100baseTX-FDX, auto > > After loading if_ep the interface appears in the output of ifconfig, but > Oct 8 21:18:17 pyosik kernel: aue0: MII read timed out > > When I then try 'dhclient aue0', I get thousands of messages > aue0: usb error on rx: IOERROR > > Any piece of advice how to make this card work would be appreciated.
Are you on a 100Mbps network? Our driver seems to have issues with this device on such networks, although it seems to work fine on 10Mbps connections. Scott -- =========================================================================== Scott Mitchell | PGP Key ID | "Eagles may soar, but weasels Cambridge, England | 0x54B171B9 | don't get sucked into jet engines" scott at fishballoon.org | 0xAA775B8B | -- Anon _______________________________________________ [EMAIL PROTECTED] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"