i have avila/cambria stuff too, but it's old (PCI, no PCIe.)
-a On 22 October 2015 at 11:06, Jeff Meegan <je...@frob.org> wrote: > I have a couple of Gateworks Avila boards that at least boot. > > On Oct 22, 2015, at 11:00 AM, Adrian Chadd <adrian.ch...@gmail.com> wrote: > > hi! > > The PC engines boards are your best bet to begin with. There's updated > ARM hardware from Gateworks but I don't recall if we ever got a port > fully working on it. > > > -a > > > On 22 October 2015 at 10:57, John Nielsen <li...@jnielsen.net> wrote: > > Hi- > > I’m working on a proof-of-concept for a kind of networking swiss army knife. > Can anyone suggest a board that meets the following requirements? CPU arch > doesn’t matter as long as it will run FreeBSD (Atom, ARM, MIPS, etc). > > - Small form factor (SoC, probably) > - Can support at least 2 802.11a/b/g/n adapters, prefer 3 (any combination > of chip-integrated and mini PCI-e slots. Prefer to avoid USB if possible) > - Has or supports at least 2 1GbE ports. Prefer 3-5 ports with switching > functionality > - Storage not super constrained. Built-in storage (if any) can be small > (which I’m arbitrarily defining as less than 128MB) if there is also an SD > card slot or similar. USB storage will do in a pinch. > - Has at least 2 free USB ports after meeting previous requirements > - Serial port or header (or GPIO pins that can be used as one? Not too > familiar with that) > - Low power consumption (within reason taking the above into account) > - Low cost (again, within reason) > > I may just start with a PC Engines apu1d, but if there are boards that are > smaller, cheaper, have lower power requirements and/or have integrated wifi > or switch capabilities I’d like to look in to them as well. > > I know that might be asking a lot, so I’m also open to any suggestions that > are most of the way there. Thanks! > > JN > > _______________________________________________ > freebsd-embed...@freebsd.org mailing list > https://lists.freebsd.org/mailman/listinfo/freebsd-embedded > To unsubscribe, send any mail to "freebsd-embedded-unsubscr...@freebsd.org" > > _______________________________________________ > email@example.com mailing list > https://lists.freebsd.org/mailman/listinfo/freebsd-wireless > To unsubscribe, send any mail to "freebsd-wireless-unsubscr...@freebsd.org" > > _______________________________________________ firstname.lastname@example.org mailing list https://lists.freebsd.org/mailman/listinfo/freebsd-wireless To unsubscribe, send any mail to "freebsd-wireless-unsubscr...@freebsd.org"