Jeff Meegan wrote this message on Thu, Oct 22, 2015 at 11:06 -0700: > I have a couple of Gateworks Avila boards that at least boot.
And only 100mbit ethernet, so failes the gige part of the requirements... > > On Oct 22, 2015, at 11:00 AM, Adrian Chadd <adrian.ch...@gmail.com> wrote: > > > > The PC engines boards are your best bet to begin with. There's updated > > ARM hardware from Gateworks but I don't recall if we ever got a port > > fully working on it. > > > > On 22 October 2015 at 10:57, John Nielsen <li...@jnielsen.net > > <mailto:li...@jnielsen.net>> wrote: > >> Hi- > >> > >> I???m working on a proof-of-concept for a kind of networking swiss army > >> knife. Can anyone suggest a board that meets the following requirements? > >> CPU arch doesn???t matter as long as it will run FreeBSD (Atom, ARM, MIPS, > >> etc). > >> > >> - Small form factor (SoC, probably) > >> - Can support at least 2 802.11a/b/g/n adapters, prefer 3 (any > >> combination of chip-integrated and mini PCI-e slots. Prefer to avoid USB > >> if possible) > >> - Has or supports at least 2 1GbE ports. Prefer 3-5 ports with switching > >> functionality > >> - Storage not super constrained. Built-in storage (if any) can be small > >> (which I???m arbitrarily defining as less than 128MB) if there is also an > >> SD card slot or similar. USB storage will do in a pinch. > >> - Has at least 2 free USB ports after meeting previous requirements > >> - Serial port or header (or GPIO pins that can be used as one? Not too > >> familiar with that) > >> - Low power consumption (within reason taking the above into account) > >> - Low cost (again, within reason) > >> > >> I may just start with a PC Engines apu1d, but if there are boards that are > >> smaller, cheaper, have lower power requirements and/or have integrated > >> wifi or switch capabilities I???d like to look in to them as well. > >> > >> I know that might be asking a lot, so I???m also open to any suggestions > >> that are most of the way there. Thanks! -- John-Mark Gurney Voice: +1 415 225 5579 "All that I will do, has been done, All that I have, has not." _______________________________________________ freebsd-wireless@freebsd.org mailing list https://lists.freebsd.org/mailman/listinfo/freebsd-wireless To unsubscribe, send any mail to "freebsd-wireless-unsubscr...@freebsd.org"