Hello, I cannot select the source host as destination when I migrate from XenCenter.
All 3 hosts use the same hardware. Disk backend for all VMs is iSCSI. Regards, Christian > -----Ursprüngliche Nachricht----- > Von: Roger Pau Monné [mailto:roger....@citrix.com] > Gesendet: Montag, 12. Dezember 2016 11:32 > An: Hoyer-Reuther, Christian; h...@dhcp-3-221.uk.xensource.com > Cc: freebsd-xen@freebsd.org; owner-freebsd-...@freebsd.org > Betreff: Re: 11-RELEASE and live migration > > On Thu, Dec 08, 2016 at 10:33:37AM +0100, Hoyer-Reuther, Christian wrote: > > I did some tests and I see the problem too. > > > > XenServer 6.5 SP1 with almost all patches (3 hosts in pool), FreeBSD 11.0- > RELEASE-p2, xe-guest-utilities-6.2.0_2 installed via pkg. > > > > First migration from host 3 to host 1 is ok. > > > > Some seconds later I start a new migration from host 1 to host 2 and when > migration finishes (as seen in XenCenter) then the VM switches to the > VGABios screen ("Plex86/Bochs VGABios (PCI) current-cvs 01 Sep 2016 ... > cirrus-compatible VGA is detected"). The VM seem to hang and does not > respond. In XenCenter I see that all the CPU's of the VM go up to 100 > percent. > > > > Then after 17 minutes the VGABios screen disappears and I see the console, > the CPU usage as seen in XenCenter goes down. I logged in as root before I > started the first migration and root is still logged in. So it was a hang > and not a reboot. > > > > 20 minutes later I start a new migration from host 2 to host 3 and the > problem occurs again. > > > > This problem does not exist with 10.3-RELEASE on the same hosts. > > Hello, > > So far I've only tested local migration (migration using the same host as > source > and destination), and that seems to work fine (I've done +50 > consecutive migrations with only 10s separation between them). Is there a > change > that you could also try to reproduce this with local migration? > > Are you using the same exact hardware on the source and the destination? Are > you > all using iSCSI as the disk backend for this VMs? > > Thanks, Roger. _______________________________________________ freebsd-xen@freebsd.org mailing list https://lists.freebsd.org/mailman/listinfo/freebsd-xen To unsubscribe, send any mail to "freebsd-xen-unsubscr...@freebsd.org"