Dimitris, What does EDDINFO [0] display?
[0] http://rayer.g6.cz/programm/eddinfo.exe On Mon, Jul 18, 2016 at 10:56 PM, Mateusz Viste <mate...@viste.fr> wrote: > I might be missing the boat here, but what you describe vaguely look > like a problem I had in some distant past, when I misconfigured my HDD > in the BIOS. > > Perhaps you could check whether your drive's geometry is 100% correct in > your BIOS? > > Mateusz > > > > > On 19/07/2016 07:12, Dimitris Zilaskos wrote: >> Hi, >> >> I was able to reinstall and boot successfully by performing an fdisk >> without FAT32 support, and creating a FAT16 2GB partition. At least with >> JEMM386, that is. So FAT32 support being the issue may be the case. >> >> Let me know if I can try anything else to confirm that. >> >> Cheers, >> >> Dimitris >> >> On Tue, Jul 19, 2016 at 6:03 AM, Dimitris Zilaskos <dimitr...@gmail.com >> <mailto:dimitr...@gmail.com>> wrote: >> >> Hi, >> >> On Tue, Jul 19, 2016 at 1:58 AM, Rugxulo <rugx...@gmail.com >> <mailto:rugx...@gmail.com>> wrote: >> >> Hi, >> >> On Mon, Jul 18, 2016 at 7:21 PM, Dimitris Zilaskos >> <dimitr...@gmail.com <mailto:dimitr...@gmail.com>> wrote: >> > >> > Thank you for following up. fdisk reports that C: drive is already >> active. I >> > did run mbrzap it completed successfully but there has been no >> change, >> > system gets stuck right after BIOS summary table. >> >> What filesystem(s) are you using? FAT32, presumably. You said >> you had >> 4 GB and 6 GB HDDs, right? >> >> Sometimes it has been noticed that a FAT32 partition is created with >> plain type 0xB instead of 0xC (LBA), so you may have to change that. >> >> http://help.fdos.org/en/hhstndrd/base/fdisk.htm >> >> I'm not entirely sure what is most informative or useful here: >> "/STATUS"? "/XO"? "/SPEC"? >> >> Honestly, I think I just used BootMgr to change it: >> >> http://www.freedos.org/software/?prog=bootmgr >> >> (This may not be your problem, I'm just grasping at straws.) >> >> >> >> Indeed the partition type is 11. I have used fdisk to change that to >> 12 but there was no change. I did a re-installation after the change >> too. >> >> Cheers, >> >> Dimitris >> >> >> > > > > ------------------------------------------------------------------------------ > What NetFlow Analyzer can do for you? Monitors network bandwidth and traffic > patterns at an interface-level. Reveals which users, apps, and protocols are > consuming the most bandwidth. Provides multi-vendor support for NetFlow, > J-Flow, sFlow and other flows. Make informed decisions using capacity planning > reports.http://sdm.link/zohodev2dev > _______________________________________________ > Freedos-user mailing list > Freedos-user@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/freedos-user ------------------------------------------------------------------------------ What NetFlow Analyzer can do for you? Monitors network bandwidth and traffic patterns at an interface-level. Reveals which users, apps, and protocols are consuming the most bandwidth. Provides multi-vendor support for NetFlow, J-Flow, sFlow and other flows. Make informed decisions using capacity planning reports.http://sdm.link/zohodev2dev _______________________________________________ Freedos-user mailing list Freedos-user@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/freedos-user
