Hi Ludwig,

On 10/13/2015 12:55 PM, Ludwig Krispenz wrote:

On 10/13/2015 12:43 PM, Oleg Fayans wrote:
Hi guys,

On 10/13/2015 12:34 PM, Petr Vobornik wrote:
On 10/13/2015 12:19 PM, Martin Babinsky wrote:
On 10/13/2015 10:15 AM, Petr Vobornik wrote:
On 10/13/2015 10:02 AM, Oleg Fayans wrote:

UI still shows the connectivity information at


Showing it is correct and desired - both in CLI and Web UI.

So IIUC the segment connectivity should not be asked interactively, but
when topology-show command is run it should show up in the output?

That's correct.

Still I do not understand what's the point in showing the user
parameters which he can not possibly change. Is there a use-case when
the connectivity can be anything else than "both"? If not, why should
we complicate the output?
it's the property of a segment. After the segment is created also
leftnode and rightnode can no longer be changed - would you hide them ?
during replica install all segments are initially created from an
agreement as left-right and then merged, the connectivity could indicate
a failure during install.

Oh, OK, that's a fair point. Thank you for clarification!
Then - yes, let's return this info into the output of topologysegment-find and *-show commands

it is just informational, but it doesn't hurt beingthere

The end state should be that UIs will create new segments with
direction=both and they will not allow to modify it.

So the issue, ticket #5222 is IMO about, is that CLI asks for a
value in
interactive prompt which could be used to change the value from
both to
some other.

CLI is OK, though

On 10/12/2015 05:57 PM, Martin Babinsky wrote:

Oleg Fayans
Quality Engineer
FreeIPA team

Manage your subscription for the Freeipa-devel mailing list:
Contribute to FreeIPA: http://www.freeipa.org/page/Contribute/Code

Reply via email to