On 07.12.2015 21:26, Günther J. Niederwimmer wrote:
Am Monday 07 December 2015, 20:41:29 schrieb Martin Basti:
On 07.12.2015 20:12, Pavel Picka wrote:
Hello
for me working if ipv6 address is e.g. 2002::101 so reverse zone will be :
0.2.0.0.2.ip6.arpa
you can use more char as you mentioned ( 0.0.0.0.0.2.0.0.2.ip6.arpa will
still be reverse for ip 2002::101 )
I tested also more chars ?
so if your IP start 2001:: have reverse 2.0.0.1.ip6.arpa
Nope.
reverse zone of 2001::/16 is 1.0.0.2.ip6.arpa
Is there a command line syntax for adding a reverse Zone, in the web Formula
it is not possible to insert a reverse IPv6 zone. I have only the Message this
is a wrong IP Address.
It should work in webUI.
Did you write ipv6 address with prefix? (2001:db8::/32) ?
Martin
hope it helps
----- Original Message -----
From: "Günther J. Niederwimmer" <[email protected]>
To: [email protected]
Sent: Monday, December 7, 2015 7:58:32 PM
Subject: [Freeipa-users] Reverse Zone IPv6 Syntax ?
Hello,
I like to create a ip6.arpa with freeIPA but this is not possible ? I
can't
found the correct syntax for a IPv6 reverse Zone :-(.
I Tested
16 Char
x.x.x.x.x.x.x.x.x.x.x.x.1.0.0.2
x.x.x.x.x.x.x.x.x.x.x.x.1.0.0.2.ip6.arpa
The last is working with named (bind)
Can any tell me, is this working or have I link to read a Docu
Thanks for a answer
FreeIPA Version 4.2.0-15
--
Manage your subscription for the Freeipa-users mailing list:
https://www.redhat.com/mailman/listinfo/freeipa-users
Go to http://freeipa.org for more info on the project
