Hello Martin, Am Tuesday 08 December 2015, 13:10:57 schrieb Martin Basti: > On 08.12.2015 12:52, Günther J. Niederwimmer wrote: > > Hello, > > > > Am Monday 07 December 2015, 22:46:45 schrieb Martin Basti: > >> On 07.12.2015 21:26, Günther J. Niederwimmer wrote: > >>> Am Monday 07 December 2015, 20:41:29 schrieb Martin Basti: > >>>> On 07.12.2015 20:12, Pavel Picka wrote: > >>>>> Hello > >>>>> > >>>>> for me working if ipv6 address is e.g. 2002::101 so reverse zone will > >>>>> be > >>>>> > >>>>> > >>>>> 0.2.0.0.2.ip6.arpa > >>>>> > >>>>> you can use more char as you mentioned ( 0.0.0.0.0.2.0.0.2.ip6.arpa > >>>>> will > >>>>> still be reverse for ip 2002::101 ) > >>> > >>> I tested also more chars ? > >>> > >>>>> so if your IP start 2001:: have reverse 2.0.0.1.ip6.arpa > >>>> > >>>> Nope. > >>>> > >>>> reverse zone of 2001::/16 is 1.0.0.2.ip6.arpa > >>> > >>> Is there a command line syntax for adding a reverse Zone, in the web > >>> Formula it is not possible to insert a reverse IPv6 zone. I have only > >>> the > >>> Message this is a wrong IP Address. > >> > >> It should work in webUI. > >> Did you write ipv6 address with prefix? (2001:db8::/32) ? > > > > No > > > > I have in my Zone only this Addresses > > 2001:15c0:xxxx:xxxx::234 > > > > ? > > Have I to set all the 0. before the /64 Segment > > No, you do not need to. > > Try to write in webUI 2001:15c0::/64 > It is shortcut form of IPv6 address, zeroes will be added automatically
That is it !!!! I have to write a "normal" IPv6 Address with Prefix, afterward the reverse ZONE are created Many Thanks Martin > >>>>> hope it helps > > > > ;-). > > > >>>>> ----- Original Message ----- > >>>>> From: "Günther J. Niederwimmer" <[email protected]> > >>>>> To: [email protected] > >>>>> Sent: Monday, December 7, 2015 7:58:32 PM > >>>>> Subject: [Freeipa-users] Reverse Zone IPv6 Syntax ? > >>>>> > >>>>> Hello, > >>>>> > >>>>> I like to create a ip6.arpa with freeIPA but this is not possible ? I > >>>>> can't > >>>>> found the correct syntax for a IPv6 reverse Zone :-(. > >>>>> I Tested > >>>>> > >>>>> 16 Char > >>>>> x.x.x.x.x.x.x.x.x.x.x.x.1.0.0.2 > >>>>> x.x.x.x.x.x.x.x.x.x.x.x.1.0.0.2.ip6.arpa > >>>>> > >>>>> The last is working with named (bind) > >>>>> > >>>>> Can any tell me, is this working or have I link to read a Docu > >>>>> > >>>>> Thanks for a answer > >>>>> > >>>>> FreeIPA Version 4.2.0-15 -- mit freundlichen Grüßen / best regards, Günther J. Niederwimmer -- Manage your subscription for the Freeipa-users mailing list: https://www.redhat.com/mailman/listinfo/freeipa-users Go to http://freeipa.org for more info on the project
