hi, I 'am using interface Group-Async , should I replace it by interface Dialer ?
Is this what you mean? > you MUST use the virtual-interface feature of cisco IOS. you can setup > timeouts only with virtual interface > > At 11.12 12/10/02, you wrote: >>hi, >> >>I am using freeradius 0.5, and sqlcounter module. >>I use the freeradius with a Patton and I got no problem auth, >> accounting, and disconnection. >> >>But when I try iy with the CISCO as5300(IOS 12.2), all the accounting >> and authentication works fine, but I got just one problem : >>the cisco can't disconnect the dialer if they reach there >> session-timeout? >> >>the cisco configuratiogn is: >> >>aaa new-model >>aaa authentication login default group radius >>aaa authentication ppp default if-needed group radius >>aaa authorization exec default if-authenticated group radius >>aaa authorization network default if-authenticated group radius >>aaa accounting delay-start >>aaa accounting exec default start-stop group radius >>aaa accounting network default start-stop group radius >>aaa processes 6 >> >> >>when I use the debug mode in cisco I got: >> >> User: ciscotesting, line tty 7, service Async >> Active time 00:03:12, Idle time 00:00:03 >> Timeouts: Absolute Idle Idle >> Session Exec >> Limits: - - 00:10:00 >> Disconnect in: - - - >> TTY: Line 7, running PPP on As7 >> Location: PPP: x.x.x.x >> DS0: (slot/unit/channel)=0/0/14 >> Line: Baud rate (TX/RX) is 115200/115200, no parity, 1 stopbits, 8 >> databits Status: Ready, Active, No Exit Banner, Async Interface >> Active >> HW PPP Support Active, Modem Detected >> Capabilities: Hardware Flowcontrol In, Hardware Flowcontrol Out >> Modem RI is CD, Line usable as async interface >> Modem Autoconfigure, Integrated Modem >> Modem State: Ready, Modem Configured >> >> User: ciscotest, line As7, service PPP >> Active time 00:03:02, Idle time 00:00:03 >> Timeouts: Absolute Idle >> Limits: - - >> Disconnect in: - - >> PPP: LCP Open, IPCP >> IP: Local x.x.x.x, remote x.x.x.x >> Counts: 226 packets input, 13485 bytes, 0 no buffer >> 0 input errors, 0 CRC, 0 frame, 0 overrun >> 207 packets output, 14700 bytes, 0 underruns >> 0 output errors, 0 collisions, 0 interface resets >> >> in the timeouts (limits and disconnect) I got no thing. >> >>is there any thing to change in the freeradius dictionary? >> >>thanks >> >> >> >>- >>List info/subscribe/unsubscribe? See >> http://www.freeradius.org/list/users.html > > > --------------------------------------- > Where's the ANY key? > --------------------------------------- > Ing. Andrea Gabellini > Email: [EMAIL PROTECTED] > Tel: 0549 886111 (Italy) > Tel. +378 0549 886111 (International) > > Intelcom San Marino S.p.A. > Strada degli Angariari, 3 > 47891 Rovereta > Repubblic of San Marino > > http://www.omniway.sm http://www.intelcom.sm > > > - > List info/subscribe/unsubscribe? See > http://www.freeradius.org/list/users.html - List info/subscribe/unsubscribe? See http://www.freeradius.org/list/users.html
