Yes I agree Helmut - it's the hard amplitude limiting of the cohpsk 
modulator waveform.  It's present in the modulator output, before the PA.

Cheers,

David

On 03/02/17 19:16, Helmut wrote:
> Hi David,
>
> I don't believe that this mentioned noise plateau - approx. 32 dB below peak
> -  of mode 700C inside the communication channel is caused by amps. Probably
> its caused by the modem itself.
>
> I run my amps with high efficient linearization due to predistortion -
> currently a new advanced beta version - achieving 60 dB IMD! Moreover the
> inside channel noise plateau is also independent of the drive level or amp
> output.
>
> 73, Helmut, DC6NY
>
>
>
>
> -----Ursprüngliche Nachricht-----
> Von: David Rowe [mailto:[email protected]]
> Gesendet: Freitag, 3. Februar 2017 07:15
> An: [email protected]
> Betreff: Re: [Freetel-codec2] FreeDV 700C early release
>
> Hi Gerhard,
>
> This actually dovetails neatly with Steve's PAPR work in the last post
> to this list.
>
> Unlike the 1600 and 800 modes, the COHPSK modulator used for 700C has
> some clipping on the output to improve the PAPR.  In some PAs, this
> means you get get a higher average power output.  In others, it may let
> the smoke out.
>
> This amplitude limiting is a form of non linearity and is probably the
> cause in the spectral regrowth at the edges of the spectrum that you are
> observing.
>
> Clipping can be disabled in the FreeDV GUI program Tool-Options menu.
>
> Cheers,
>
> David
>
>
> On 03/02/17 16:26, Gerhard Burian wrote:
>> Hi David,
>>
>> When I was testing the different modes with websdrs I recognized higher
>> sideband noise (shoulders) in 700C mode compared with 800XA and 1600 mode
> at
>> the same settings on my ANAN-100D. I am using narrow filtering on TX and
>> pure signal. So I don't have an explanation for that.
>>
>> Regards
>> Gerhard
>>
>> -----Ursprüngliche Nachricht-----
>> Von: David Rowe [mailto:[email protected]]
>> Gesendet: Dienstag, 31. Jänner 2017 11:40
>> An: [email protected]
>> Betreff: Re: [Freetel-codec2] FreeDV 700C early release
>>
>> I been sending a few SSB/700C test signals of 800 - 1500 km paths on 40M
>> using a websdr to pick them up at the other end.  In marginal conditions
>> with SSB down in the noise I'm getting sync and audio through on 700C.
>> Not sure if I have the same average tx power though.
>>
>> Also had a 700C QSO with a guy interstate.  SSB very noisy but 6-8dB SNR
> on
>> 700C.  Noise free but some issues with his audio and the modem loosing
> sync
>> every few seconds.
>>
>> Lot of frequency selective fading in both tests.
>>
>> Promising start....
>>
>> - David
>>
>>
> ----------------------------------------------------------------------------
>> --
>> Check out the vibrant tech community on one of the world's most engaging
>> tech sites, SlashDot.org! http://sdm.link/slashdot
>> _______________________________________________
>> Freetel-codec2 mailing list
>> [email protected]
>> https://lists.sourceforge.net/lists/listinfo/freetel-codec2
>>
>>
>>
> ----------------------------------------------------------------------------
> --
>> Check out the vibrant tech community on one of the world's most
>> engaging tech sites, SlashDot.org! http://sdm.link/slashdot
>> _______________________________________________
>> Freetel-codec2 mailing list
>> [email protected]
>> https://lists.sourceforge.net/lists/listinfo/freetel-codec2
>>
>
> ----------------------------------------------------------------------------
> --
> Check out the vibrant tech community on one of the world's most
> engaging tech sites, SlashDot.org! http://sdm.link/slashdot
> _______________________________________________
> Freetel-codec2 mailing list
> [email protected]
> https://lists.sourceforge.net/lists/listinfo/freetel-codec2
>
>
> ---
> Diese E-Mail wurde von Avast Antivirus-Software auf Viren geprüft.
> https://www.avast.com/antivirus
>
>
> ------------------------------------------------------------------------------
> Check out the vibrant tech community on one of the world's most
> engaging tech sites, SlashDot.org! http://sdm.link/slashdot
> _______________________________________________
> Freetel-codec2 mailing list
> [email protected]
> https://lists.sourceforge.net/lists/listinfo/freetel-codec2
>

------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, SlashDot.org! http://sdm.link/slashdot
_______________________________________________
Freetel-codec2 mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/freetel-codec2

Reply via email to