In a message dated 4/6/02 4:03:16 PM, [EMAIL PROTECTED] writes:
<< My G3 ROM and Mobo are Revision C. The production date is 12/22/1998. The HDD I want to install is a DSAA 350 MB IBM out of a Performa 638CD. I think the spindle speed is 4200 RPM which is slow compared to todays drives. The wiring hookup appears to be the same thing as the G3 with a 40 pin data cable and 4 wire power cable. Will this drive work on IDE bus 1 with the CD and if so should I run it as master or slave? Any and all replies greatly appreciated. >> Yes. Master or Slave theoretically doesn't matter as they are really "peers" of each other. However, I would be consistent with Beige G3 de-facto standards and set the drive behind the CD-ROM as Slave. Leave the CD-ROM as Master. >> BTW, Peter, you seem to be the man on G3's, where can I lay my hands on a repair manual for this machine? Beige G3 DT/266. >> >> For manuals, try: http://home.wanadoo.nl/manual.man/manuals.html -- G-List is sponsored by <http://lowendmac.com/> and... Small Dog Electronics http://www.smalldog.com | Refurbished Drives | -- We have Apple Refurbished Monitors in stock! | & CDRWs on Sale! | Support Low End Mac <http://lowendmac.com/lists/support.html> G-List list info: <http://lowendmac.com/lists/g-list.shtml> Send list messages to: <mailto:[EMAIL PROTECTED]> To unsubscribe, email: <mailto:[EMAIL PROTECTED]> For digest mode, email: <mailto:[EMAIL PROTECTED]> Subscription questions: <mailto:[EMAIL PROTECTED]> Archive: <http://www.mail-archive.com/g-list%40mail.maclaunch.com/> Using a Macintosh? Get free email and more at Applelinks! <http://www.applelinks.com>
