A mask of 255.255.255.255 (or equivalently /32) is just a single IP address, so A.B.C.D/32 is the same as just A.B.C.D. (Unless I misunderstood something you said).
Mike Burden Lynk Systems http://www.lynk.com (616)532-4985 [EMAIL PROTECTED] > -----Original Message----- > From: Roger Cornelius [mailto:[EMAIL PROTECTED]] > Sent: Friday, January 25, 2002 5:21 PM > To: [EMAIL PROTECTED] > Cc: [EMAIL PROTECTED] > Subject: [gb-users] GBL/GBP problems > > > In at least 3.2.2 and 3.2.3 GBL and GBP, Gnatbox forgets mask settings > on RA filter objects, if the mask is all ones. > > Using the web interface to create a new RA filter and specifying > <USE IP ADDRESS> for the source and destination objects, enter > <some ip address>/255.255.255.255 for the IPs. > > Click OK and once the menu of RA filters comes back up, the masks have > changed to 32, i.e. <some ip address>/32. Now click the > checkmark next > to the filter in order to edit it. The filter comes up and > the IPs are > there with the /32 mask. Click OK again (no changes have > been made) and > when the menu of RA filters comes back up, the masks have disappeared. > Clicking the checkmark to edit again confirms this. The IPs are still > there, but without the mask. > > If I initially create the filter with a mask of 32 instead of > 255.255.255.255, then click OK, the masks have disappeared once the RA > filter menu comes back up. > > Am I misunderstanding something? > > > Also, it appears the Unix/Linux Installation instructions in > the manual > are wrong. This is under the Software Installation section in Chapter > 4. Under step 7, where it describes reading and writing only the > configuration data, the command for reading the config data should use > the dd skip= option (rather than seek=) and the command for > writing the > config data should use seek= rather than skip=. > > -- > Roger Cornelius [EMAIL PROTECTED] > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [EMAIL PROTECTED] > To subscribe to the digest version first unsubscribe, then > e-mail: [EMAIL PROTECTED] > For additional commands, e-mail: [EMAIL PROTECTED] > > > --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] To subscribe to the digest version first unsubscribe, then e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
