ROTFL!!! That would have been priceless to see. Damn nut anyway. <S> Burke
Chuck Snyder wrote:
> I would recommend taking a single edged razor
> blade and trying to work it into the seam in the
> glass from both sides. You will have to run it up
> and down over and over. The thin blade should
> eventually be able to be worked into the seam from
> the open end and act like a wedge to open it up.
>
> If you go with the break it method, duct tape both
> sides to keep it from going all over the place and
> be sure to wear goggles.
>
> My favorite method is to put the tank on end
> directly behind the band saw. Next you attempt to
> cut a coconut in half with the band saw. Then,
> while not holding the coconut firmly in your
> hands, allow the saw blade to catch in the nut and
> pull it out of your wimpy grasp. Aforementioned
> fruit will then roll off the back of the band saw
> and fall onto the side of the aquarium, thus
> shattering the glass. It is now very easy to
> remove the glass. However if your intention was to
> cut a coconut in half (as was mine) you have to go
> to plan C, this time with the tank far, far
> away...
>
> --
> Regards...
> |===================>
> Chuck Snyder
> Pittsburgh PA, USA
> Rhac 'n Roll
> <http://home.netcom.com/~deadrats/h.htm>
> GGA <http://www.gekkota.com>
>
> ###########################################################################
> THE GLOBAL GECKO ASSOCIATION LISTSERV
> WebSite: www.gekkota.com Archive: [EMAIL PROTECTED]/
> The GGA takes no responsibility for the contents of these postings.
> ###########################################################################
