On Thursday 15 May 2008 06:58:20 pm Erik Winn wrote: > I definitely will. In fact, I have a question about output already - I was > messing around with merging just using gerbv as a filter and ran into what > _might_ be an error: the output includes a starting coordinate of X0Y0 at > the very start. Here's an example: > > G04 --Start main section--* > G01X00000Y00000D02* > G54D11* > G01X00394Y02344D02* > > This actually broke the sizing on my web-parser as the board itself does > not start there, but rather at the coordinate that comes right after the > tool prepare (G54). So, I am wondering why the extra is there - I don't > find this in any other output that I have tested the web parser against so > far, so I am thinking that it is possibly a technically correct thing that > nobody uses .. that might be omitted?
In fact, now that I look more closely, it does this again a few lines later before another tool prepare - this was after I had merged an outline layer with a silk layer. I can send you the two files if you like Julian. The entire design is offset in both files. -- Erik Winn BatchPCB.com [EMAIL PROTECTED] _______________________________________________ geda-dev mailing list [email protected] http://www.seul.org/cgi-bin/mailman/listinfo/geda-dev
