Erik Winn wrote: > Hi again, > > BTW, I have just checked out gerbv 2.1-trunk - builds nicely (after a manual > libtoolize ..)
autogen.sh should have taken care of that for you. If not, then let me know and I'll fix it. > and looks great. And, it successfully imported a full panel > (all layers) afterwards exporting it to what looks to my (only somewhat > tutored) eye like legal rs274x. I don't know how nailed down the interface is, but gerbv was just split apart into libgerbv which contains things like the rs274-x and drill file parsers and then the actual application. Don't know if that would be useful to you in your work. You might ask on the gerbv developers list. It is a low traffic list and at least one of the key gerbv developers I think doesn't read this one. > Very nice work. I would point out though that > the G01 (linear interpolation) is usually omitted from the coordinates in > most of the files I have dealt with - my understanding is that it is more of > a reset command, I rarely see it (except from FreePCB and PADS). I don't know > if this will cause problems (its perfectly legal according to all the specs I > have been able to find), but I do know that it is rare. I think at one time there was some interest in making the output of gerbv be a more common subset of rs274-x so this would be good to feedback to the gerbv developers list too. -Dan _______________________________________________ geda-dev mailing list [email protected] http://www.seul.org/cgi-bin/mailman/listinfo/geda-dev
