Jeff VR wrote: > Hello, > It seems the only room for error is in the batchpcb project submission > page where it inquires about the software tool used for the design. I > think this is for the drill file number format. I'm not really sure > what I needed to put there so I tried a few different options. I opened > the drill file and it looked like the format was "1.3 normal".
While I can't say for sure, I believe "1.3 normal" is what I have used successfully in the past with BatchPCB. > > My design didn't have a back silk screen layer so I created a simple one > by hand but that didn't get around the issue either. > > This is what the log file generates from batchpcb's drc checker for both > the top and bottom layers: > Beginning GCODE run > Invalid DCODE 0 > GCode execution failed! But... this isn't a complaint about the drill layer, is it? Isn't this whining about top and bottom copper? -dave _______________________________________________ geda-user mailing list [email protected] http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
