I'm sure this is a horribly obvious question/answer to some, but the documentation is simply not helpful to me in this regard.
I'm using the rectangle/polygon tool to create ground planes. But I cannot figure out how to assign that plane to the "GND" net or the "VCC" net or whatever! So of course PCB creates clearances for the polygon with every pad it comes in contact with, including GND pads. Not helpful. The copper pad is floating, not connected to any net, and I can't figure out how to unfloat it even after reading pcb-tips and the main pcb documentation page... It is very descriptive on how to create a polygon, just not how to use it! In EAGLE it is easy, you just create the polygon, click "Name" and click the polygon, and type the name of the net to assign the plane to, and clearances/connections are handled automatically. I do not see an equivalent command here, so I'm more than a little confused. Best regards, James Johnston _______________________________________________ geda-user mailing list [email protected] http://www.seul.org/cgi-bin/mailman/listinfo/geda-user
