Hi all folks, Just join this list.
I am going to install Gentoo (2 CDs) on a RAID-0 box and am uncertain whether I have to issue following command at prompt when installation begins; # gentoo doataraid Connection of hard drives PCI RAID controller - z-cyber,0,1,0+1 1st hard drive - connected to 1st slot of the controller as master 2nd hard drive - connected to 2nd slot of the controller as master The controller is detected by the bios of motherboard. Win2K was working on it without problem. A single hard drive of (2 x hard drive) capacity was seen by Win2K Kindly advice. Thanks in advance. B.Regards Stephen Liu To Get Your Own iCareHK.com Email Address? Go To www.iCareHK.com. -- [EMAIL PROTECTED] mailing list
